Here are picts of my working grenade launcher on
my heavily modified G&P kit. It is using a 27mm
CAW grenade from a PEQ2 kit. Plus a altered
remington 870 trigger assy. and many custom ABS
and metal pieces I made. Someday I will have to document
this whole thing properly. Here's a break down:
1. Front view. You can see the laser that is mounted
in the rear of the barrel vent. Also, the bezel I
made for the light gate to work with the Phil S.
barrel triangle
www.hooverae.com/upload/pics/gren1.jpg 2. Side view. The grenade and the battery underneath.
I cut out all the vents of the cage and repositioned
the slide connection of the pump. The cage
is reinforced with brass extruded pieces inside for
strength.
www.hooverae.com/upload/pics/gren2.jpg 3. I real working allen bolt.
Let's just say I did a lot of dremeling.
This removes the block and grenade.
www.hooverae.com/upload/pics/gren3.jpg4. Here it comes out.
www.hooverae.com/upload/pics/gren4.jpg5. The grenade block collar with the Nades.
www.hooverae.com/upload/pics/gren5.jpg6. Custom collar I made with 1-1/8 steel pipe.
Allen set screws on the side of the block lock
it in place.
www.hooverae.com/upload/pics/gren6.jpg7. Internal view. This shows the mounting plate
for the grenade. The firing pin is in the center.
This is linked to the 870 trigger by a metal bar
and modified trigger hammer.
www.hooverae.com/upload/pics/gren7.jpgFinally posting some picts. I've had this thing done
since May for OP lionclaw4. It is my only AS gun.
Until I get my koba vp for my bday this month.
It was tons of work, but I'm happy the way it turned
out.
Register
FAQ
Search
Login
